what are some of the options youve added to this interface board
i am getting this setup and would like to know what extras i can do with this on my bike
Sure .
control (How many stages will depend on the processor you use)
Boost control. (How many stages will depend on the processor you use)
Water injection control
Shift lights control
auto shifter and auto kill
Extra injector drivers for using the Dual processor board
two 8 Bit processors for whatever you want PWM,air shifter auto kill,ect programmable on the board but you will need a SX key to program them they run around 65.00
4 10amp realys on board
4 high current IGBT's for the c.o.p ignition
Dual Vr sensor conditioners for the crank and cam sensors
Plenty of General purpose outputs for turning stuff on and off
The board is setup to use high ohm injectors or you can buy a P&H board and run low ohm injectors in Peak and hold mode the hookups are already on the board
Dual frequency to voltage converters for logging output shaft speed and clutch basket speed (these are untested so it is unknow to me if they work yet)
Large Proto area for prototyping more circuits on the board all the extra options are easy to configure with simple jumpers to the appropriate header .
There is 8 IRLZ44n high power Mosfet's on board to switch high current devices on and off like shift solenoids,boost solenoids, water injection valves,ect
And the best part is it will be plug and Play with the stock harness ( i may require some additonal wires for grounding but i will do my best to supply the pins and wires for this also)
Alot of the unused pins on the stock harness are brought out so you can just add a pin to the stock connector and have a extra output or input without adding any headers to the box.
There should be PLENTY of flexibility with this board to do whatever you want with it.
This board should also work with any MS box out right now so it should be easy to interface between the harness and the MS box you have.
